FIBER LASER MARKING MACHINE

IntroductionThe AHL-FB10 laser marking system is a fiber laser marking system whom push to the world by the cooperation of Aohua laser and Germ an laser company. Compared with the semiconductor laser marking system, the light beam quality is higher and the effect of careful engrave is better. It needn’ t consumes the material and the cost of depreciation is reduced greatly. It is one of the successful models through the cooperation of Aohua and German laser company.

Technical parametersAHL-FB10
Max. laser power: 10W
Laser wave-length: 1064nm
Beam quality: <2M2
Repetition frequency: 20KHz-100KHz
Standard marking area: 100mm×100mm
Marking area option: 50mmX50mm 150mm X150mm 200mm×200mm
Marking depth: ≤1.2mm
Linear speed: >800 Standard characters /s
Min. line width: 0.01mm
Min. character: 0.15mm
Repetition accuracy: ±0.002mm
Power consumed: ≤160W
Electrical source: 220V±10%/50Hz/4A
Laser: IPG
Laser module lift: >100000h
Resonance: SCANLAB
Cooling system: Air
Control link: USB

System components and environmental requirementsSystem components: Mainframe, optional workstations and computer
Software: AHLASER MARKER SYSTEM, Support WIN98/WIN2000/WINXP
Supplies: filter, water, electricity
Installation Environment: It occupies an area of 10 square meters and should by put steadily.
Working environment: smoothly in a clean environment without vibrating or dirt in the air because the dirt will make the mirror dirty and reduce its lift sharply.
Temperature of the environment: 25℃―28℃
Humidity of the environment: 5% to 75% (no condensation)
Power supply: 220VAC ±5% 50HZalternating current capacity, it should be more than 1KW, has null line and separate earth wire which should be connected with the earth well. The circuit breaker should be set specially for the machine (C32) and it should equip with electric leaking protecting device.

Samples