- Laser Marker
- ......YAG Laser Marker
- ......CO2 Laser Marker
- ......Diode side-pump Laser Marker
- ......Diode end-pump Laser marker
- ......Fiber optic Laser Marker
- ......Flying marking system
- Laser welder
- ......Mould welding system
- ......Laser welding system
- ......Laser spot welder series
- ......Fiber optic laser welder
- Laser cutter
- ......YAG Laser cutting system
- ......CO2 Laser cutting system
- Laser Trimming system
- Laser slicer system
- Laser peeler system
- Ancillary
- Special equipment
- ............Bearing Laser marker
- ............Button Laser marker
- ............Crystal Laser marker
- ............Glass Laser marker
- ............Keyboard Laser marker
- ............Label Laser marker
- ............PCB Laser marker
- ............Sensor Laser welder
- Samples
- CONTACT US
It use imported high speed scan resonance and Q-switch system, so it need only ten seconds to mark a common standard keybord. The machine function steady and can con tinue to work for 24 hours.
Download:
Profiles and parameter Download
List of equipment Download
Installation diagram Download
Installation guide early Download
routine maintenance Download
Technical parametersLaser wave-length: 1064nm
Repetition frequency: ≤50KHz
Standard marking area: 300mm×300mm
Linear speed: ≤7000mm/s
Min. line width: 0.02mm
MAX. Speed: 10s/Keyboard
Repetition accuracy: ±0.002mm
Electrical source: 220V±10%/50Hz/30A
System components and environmental requirements Software :AHLASER MARKER SYSTEM, Support WIN98/WIN2000/WINXP
Installation Environment :It occupies an area of 5 square meters and should by put steadily.
Working environment : smoothly in a clean environment without vibrating or dirt in the air because the dirt will make the mirror dirty and reduce its lift sharply.
Temperature of the environment: 25℃―28℃
Humidity of the environment: 5% to 75% (no condensation)
Power supply: 220VAC ±5% 50HZalternating current capacity, it should be more than 6KW, has null line and separate earth wire which should be connected with the earth well. The circuit breaker should be set specially for the machine (C32) and it should equip with electric leaking protecting device.
Samples
Copy Right:SHENZHEN AOHUA LASER TECHNOLOGY CO.,LTD HTTP:\\WWW.AHLASER.COM Email:english@ahlaser.com
Address:Longjing Industrial park,Yangmei,Bantian Longgang district Shenzhen,Guangdong,China Post Code: 518112 
Mobile: 0086+13823500965 TEL: +86-755-88869818 (16line) FAX: +86-755-84505046